paper board making machine dewatering elements equipment Cylinder Mould
Product Description
This machine is used for the first set of finishing equipment behind the paper machine. The roll cylinder is operated actively, and the roll is driven by friction to complete the paper winding. By adjusting the pressure of the auxiliary arm and the cylinder of the main arm to adjust the linear pressure between the roll and the cylinder, the operation can meet the needs of different kinds of paper and make the paper rolled down from the paper machine into a compact and uniform roll paper.
Cylinder Mould includes spindle, mesh frame, spokes and spacer, the spokes are set on the spindle at equal intervals, the mesh frame is installed on the spokes, stainless steel spokes are installed at equal intervals between the spokes on the spindle, replacing some of the spokes and a stainless steel support ring is embedded in the outer end of the support strip, the mesh frame is installed along the support ring and the outer edge of the spokes and is tightened with stainless steel wire wrapping, as the main components are made of stainless steel, and some of the spokes are replaced by spokes, which is light in weight, corrosion-resistant, and lowers the energy consumption and reduces the maintenance cycle of the equipment.
Main Features
1.Cylinder section:1500mm×2350×2900mm stainless steel cylinder mould 1set,equipped with bearing (113622) and one set Pulp-spraying Pressure former,speed regulation holy roll make the finished paper with good evenness.Consistency is about 0.1-0.15%,mesh count(90-100)more than 2layers .Which the pulp go on the mesh ,it will not throw pulp and not leave any trace during the production,the finished paper can have good tension ,strength and evenness in vertical and horizontal.
2.Couch roll section:Size of couch roll is 450mm×2350×2900mm,material of roll body is seamless steel pipe.Thickness is 14mm .Roll surface is coated by rubber ,rubber thickness is 25mm .Rubber ,rubber hardness HSD 38ºC±2,equipped with bearing(113518).
3.Frame:Frame of cylinder section is welded with shaped steel.Thickness is 10mm.
4.Washing device of cylinder section:Pulp-spraying Pressure former adapt water pressing type.Spray pipe DG32 stainless steel .Ceramics hard wearing nozzle .
5.Felt washing section:High pressure cleaning device 2 sets,spray pipe washer adapt water pressing type .Spray pipe DG32 stainless steel .Ceramics hard wearing nozzle .
| 1 |
Product name |
Cylinder mould |
| 2 |
Type |
Ф1500X2100 |
| 3 |
Matched beaeing |
113520 |
| 4 |
Structure |
Stainless steel wound type |
| 5 |
Main axis |
Ф219 |
| 6 |
Wheel spoke |
Cast iron HT150 |
| 7 |
Bar diameter |
12*2100 |
| 8 |
Belt |
1.5 |
| 9 |
Spindle nose |
45# round steel conditioning |
| 10 |
Diameter |
1500mm |
| 11 |
Face length |
200mm |
| 12 |
Diameter of SS stick |
12mm |
| 13 |
Qty of SS stick |
80 |
| 14 |
Qty of middle support chip |
14 pcs |
| 15 |
Thickness of SS strip |
15mm |
| 16 |
Diameter of axis |
180mm |
){kind=link}